Losi XXX-S Sport - Manual (Page 25)

110
109
156
104
110
Small Groove in
Extra Short Shaft
Only
108
105
104
106
107
22
Step F-1
Step F-2
q 1. Place one Shock O-ring (105) into the Cartridge Body (104),
making sure that the O-ring sits flat in the bottom of the Cartridge
Body.
q 2. Insert the Cartridge Spacer (106) into the Cartridge Body fol-
lowed by a second O-ring.
q 3. Once the second O-ring is inserted, and is flush with the top of
the Cartridge Body, press the Cartridge Cap (107) onto the Cartridge
Body until it snaps in place.
q 4. Make four Cartridge assemblies.
Cartridges in some kits may be pre-assembled at the factory.
Figure 50
Figure 51
Step F-3
Figure 52
105 106
BAG F
q 1. Place a drop of Shock Fluid (115) on the grooved end of each
Front Shock Shaft (156), and each Rear Shock Shaft (108). Slide a
Cartridge , hex end first, down the Shock Shaft towards the threads as
shown in Figure 51, on all four Shafts.
q 2. Using pliers or small vise grips, grasp the Shock Shaft between
the grooves and thread a Shock End (109) all the way onto the Shaft
until the threads stop.
q 3. Repeat Step 1-2 on all four Shock Shafts.
q 4. Carefully snap a 1/4" Aluminum Shock Mount Ball (110) into
each of the Shock Ends on each of the four Shock Shafts.
110
q 1. Snap a 1/8" E-clip (112) into the groove closest to the Car-
tridge on both Front (156), and Rear Shock Shafts, (108).
q 2. Slide a "Red", #56 Shock Piston (113) onto all four shock shafts
until the Piston rests against the E-clip (112). Secure the Pistons to
the Shafts with a second E-clip.
Front
Rear
112
Shock Cartridge Assembly
Shock Shaft Assembly
Shock Piston Install
108
156
Rear
Front
112
108
113 113
156