Bag e (continued) – Losi XXX-S Sport User Manual
Page 23
58
85
95
155
BAG E (Continued)
20
Step E-8
Figure 46
Step E-9
Figure 47A
Step E-10
Figure 48
Figure 47B
q
1. Attach the Left Rear Hub (101) assembly to the Left Rear Arm
(92) by aligning the holes in the Rear Hub with the inner-most of the
outer holes in the Rear Arm. Insert a 3/32" x .930" Hinge Pin (81)
through the Arm into the Hub as indicated in Figure 46.
q
2. Make sure the Hinge Pin is centered between the ends of the
Arm. Secure the Hinge Pin by threading a 5-40 x 3/16" Set Screw (82)
into the outside of the Rear Hub.
q
3. Repeat Steps 1-2 for the Right Rear Hub (101) assembly.
81
q
1. Thread a Plastic Rod End onto each end of a 1.125" Titanium
Turnbuckle (83). Tighten both Rod Ends (58) equally until the overall
length is the same as the Tierod in Figure 47B. Make two of these Tie
rod assemblies.
Each end of the Turnbuckle is threaded opposite. One end has
right-hand threads, the other has left-hand threads. This allows the
length of the rods, once installed, to be adjusted without removing
them.
58
The "Foam Things" are primarily for use on dusty, out-door
tracks and surfaces. Their use is left to your discretion.
q
1. Place a "Foam Thing" (85) over the Ball Stud (155) in the Rear
Hub (101). Place a second "Foam Thing" over the Ball Stud in the
Rear Shock Tower (95).
q
2. Snap the end with the Right-Hand Threads on the Turnbuckle
assembly to the Ball Stud in the Left Rear Hub. Snap the other end to
the Ball Stud in the Rear Shock Tower.
q
3. Repeat Steps 1-2 to attach the other Turnbuckle assembly to
the Right Rear Arm (92) assembly.
Assure that the Right-Hand Threads on the Turnbuckle are
located towards the outside of the chassis for easier adjustment
later.
Rear Hub Assembly Install
Turnbuckle - Rear Camber Link Assembly
Turnbuckle - Rear Camber Link Install
83
81
82
101
92
82
83
58