Losi XXX-S Sport - Manual (Page 20)

32
92
151
93
61
91
62
91
31
27
BAG E
17
Step E-1
Step E-2
There are optional “High Roll Center” pivot blocks included
in Bag H of this kit. See set up tips at the end of this manual for their
uses.
q 1. Install a Rear Inner Pivot Block (91) by threading two 4-40 x
3/8" Flat Head Screws (31) through the bottom of the Chassis (27)
into the Pivot Plock as indicated in Figure 39. Repeat for the right Rear
Inner Pivot Block (91). The Rear Inner Pivot Blocks are interchangeble
from left to right.
There is a short thread-cutting screw included in the wrench
bag. This screw can be used to tap threads in the holes in the Rear
Inner Pivots. Pre-tapping these holes makes it easier to install the
Screws during assembly.
Figure 39
Figure 40A
31
q 1. Slide an Inner Hinge Pin (62) through each of the two Rear
Arms (92) farthest away from the Shock mounting holes.
Before you tighten the Main Block it may be necessary to
slightly loosen the screws in the Inner Pivots about 1 full turn. Once
this is done, tighten the Main Block, followed by tightening the
Inner Pivots. This will ensure you get the correct Pin angle in the
Arms
q 2. Position the RearArms (92) so that the Shock mount holes face
away from the back of the Chassis (27). Slide a .060" Spacer (61) over
each side of Inner Pins as indicated in Figure 40A. Insert the Arms
into the Inner Rear Pivot Blocks (91). Capture the Rear Arms by plac-
ing the Rear Main Block (93) onto the Inner Hinge Pins as shown in
the illustration in Figure 40B. Secure the Rear Main Block by thread-
ing two 4-40 x 1/2" Flat Head Screws (151) through the Main Block
into the Lower Holes in the Rear Diff Cover (32).
There is a short thread-cutting screw included in the wrench
bag. This screw can be used to tap threads in the holes in the Rear
Diff Cover. Pre-tapping these holes makes it easier to install the
Screws during assembly.
61 62
Figure 40B
151
Rear Inner Pivot Install
Rear Arm Install
ASSEMBLE MAIN BLOCK
IN THIS DIRECTION