Losi LOSB0012 Getting Started Guide - Manual

GETTING STARTED GETTING STARTED
NOTE: Before you start running your Aftershock, read your engine break-in and operating
instructions. If you run your Aftershock without following proper break-in procedure,
you may damage or fail to get maximum performance from your engine, and void the
warranty.
Page 1
Install the 8 AA-size alkaline batteries in the trans-
mitter making sure the positive (+) and (-) negative
ends are oriented correctly. Use only quality alkaline
or rechargeable NiMH (nickel-metal hydride) AA size
cells.
Radio Batteries
2
Antenna Tube
Find the antenna tube in the plastic bag with the Operations
guide . Thread the black antenna wire attached to the receiver
through the mounting boss (fig. 1A) on the right side of the
radio box and through the antenna tube. Push the antenna
tube (fig. 1B) into the mounting boss on the side of the radio
box.
1A
1B
5 cell Receiver Pack
4D
5 cell RX Pack
To install a rechargeable battery pack, turn the chassis over and
using the included 1/16" Allen wrench, remove the four screws
(fig. 3A) securing the battery mount. Install the battery pack
(fig. 3B) with the plug and wires going through the grommet hole
(fig. 3C) in the chassis. Re-install the battery mount and the four
screws that secure it. Plug the battery lead (fig. 3D) into the wire
harness.
3A 3B
3C 3D