Bag e (continued) – Losi XXX-S Sport User Manual
Page 22
THREAD
LOCK (79)
72
74
77
75
73
RED
LUBE (78)
BAG E (Continued)
19
Step E-5
Figure 43
Step E-6
Figure 44
Step E-7
Figure 45
q
1. Thread a 0.200" Short Neck Ball Stud (155) into the inside hole
("A") in the top of the Left Rear Hub Carrier(101) as indicated in
Figure 43.
q
2. Insert a 3/16" x 3/8" Bearing (25) into the back-side of the Left
Rear Hub Carrier. From the front-side, insert a Bearing Spacer (71) as
illustrated in Figure 43. Capture the spacer with another 3/16" x 3/8"
Bearing, from the front side of the Hub. Make another assembly for
the Right Rear Hub (101).
25
71
q
1. Apply a thin coat of Red MIP Thrust Bearing/ Assembly Grease
(78) to the outside of the CVD Coupling (74). Insert the greased CVD
Coupling into the large hole in the CVD Axle (72) so that the cross-
hole in the Coupling can be seen through the slots in the Axle.
q
2. Place the CVD Dogbone (73) over the CVD Axle. Align the
holes in the CVD Dogbone with the hole in the CVD Coupling. Secure
all three parts by inserting a 1/16" x 7/16" (solid) Pin (75) through the
holes in the CVD Dogbone, the slots in the CVD Axle, and the hole in
the CVD Coupling.
q
3. Center the Pin in the CVD Dogbone and secure it by applying
a small amount of MIP Thread-Lock compound (79) to a 4-40 x 1/8"
Set Screw (77), and thread it into the end of the CVD Coupling.
Apply the enclosed Thread-lock to the Set Screw before thread-
ing it into the CVD Coupling. If Thread-lock is not used, the Set
Screw will loosen during operation. This will cause your car to stop
running.
q
4. Repeat Steps 1-3 for the second Rear CVD assembly.
74
75
q
1. Insert the CVD throught the 3/16" x 3/8" Bearing (25) from the
inside of the Hub (101) until the shoulder of the CVD Axle (72) stops
at the Bearing. Slide a 3/16" x .015" Shim (150) over the Axle (72)
against the outside Bearing. Secure the axle and shim by placing a
1/16" x 5/16" (spirol) Pin (76) through the cross hole in the Axle. The
Pin should be centered in the Axle.
q
2. Repeat for the Right Rear Hub (101) assembly.
150
76
Rear Hub Carrier Assembly
Rear CVD Assembly
Rear Hub Assembly
155
77
101
71
25
155
150
25
101
76
72