Kontron PCI-760 User Manual
Page 57

10. AMI BIOS Configuration
PCI-760 – User’s Guide (V1.10)
55
10.3.7.2.
Serial port number
This option allows you to select the serial port for console redirection.
The available settings are:
COM1
COM2 and COM3.
The COM 3 interface is an internal virtual serial interface of the ICH9DO that allows remote access via
the LAN1 (AMT LAN Controller).
10.3.7.3.
Serial Port Mode
This option allows you to select the serial port features (Speed, Data Bits, Parity, StopBits) for a proper data transfer with
the client system.
The available settings are: 115200 8,n,1 / 57600 8,n,1 / 38400 8,n,1 / 19200 8,n,1 / 09600 8,n,1.
10.3.7.4.
Flow Control
Flow Control lets computers (host and client) tell each other when they can accept more data for transmission and when
to wait. This handshaking prevents data from being lost because one computer was busy.
The available settings are:
None
,
Hardware and Software.
10.3.7.5.
Redirection After BIOS POST
This option allows you to select when the console redirection will be used.
Always
Redirection is always active. (Some OSs may not work like expected if this setting is chosen.)
Boot Loader
Redirection is active during POST and during Boot Loader.
Disabled
Turns off the redirection after POST.
10.3.7.6.
Terminal Type
This option allows you to select the target terminal type.
The available settings (industry standard terminal protocol) are:
ANSI
,
VT 100 and VT-UTF8.
10.3.7.7.
VT-VTF8 Combo Key Support
This option allows you to enable or disable the VT-UTF8 Combo Key Support for ANSI/VT 100 terminals.
It is possible to choose between:
Enabled
and Disabled.
Client and target systems must have the same settings for a working communication.
10.3.7.8.
Sredir Memory Display Delay
This option allows you to pause the memory display during redirection for the set value.
Available settings are:
No Delay,
Delay 1 Sec, Delay 2 Sec
and Delay 4 Sec.