Jumpers and connectors overview – Kontron PCI-760 User Manual
Page 17

9. Jumpers and Connectors Overview
PCI-760 – User’s Guide (V1.10)
15
9.
Jumpers and Connectors Overview
The jumpers and connectors of the PCI-760 board will be described in detail below.
Signals suffixed by a pound (#) are active-low.
All headers will have a pitch of 0.100" (2.54mm), otherwise noted different.
Connectors on the I/O Panel
J36 VGA
Connector
J25
LAN1 Connector
J26
LAN2 Connector
J29 USB7
Connector
J30 USB6
Connector
On-Board Jumpers
JP1
COM2 (RS422) Enable Termination Resistors
JP2
COM2 (RS485/422) Enable Termination Resistors
JP3
Conn. for Ext. Temp. Sensor (not supported)
JP4
Always POWER ON (not supported)
JP5
RTC Reset (Clear CMOS)
JP6
Disable Backup Restore Function
JP7
TPM Physical presence (reserved)
JP8
Image Flash; BIOS programming (before BIOS update contact our Technical Support Department)
JP9
Reset Management Engine (reserved)
JP10
Enable/Disable the HDACT LED of the USB Flash Module
On-Board Connectors
J1, J4, J24
12V Fan Connectors (3-pin)
J31
12V ATX Power Connector (4-pin)
J14
Multifunctional Connector (16-pin)
J15
Serial Connector COM1 (10-pin)
J16
Serial Connector COM2 (10-pin)
J8
Parallel Connector LPT (26-pin)
J22
SPDIF-IN&-Out Connector (5-pin)
J32
Keyboard Lock Connector (2-pin)
J33 Suspend-LED
(2-pin)
J34
Additional Power Button Connector (2-pin)
J20
Audio Connector (10-pin) (Line-in, Line-out, Mic.)
J23
Audio Connector (10-pin) (Surround L/R, Side surround L/R, Center/LFE)
J13
USB header (USB4+USB5) (9-pin+key)
J19
USB header (USB8+USB9) (9-pin+key)
J10
USB header (USB10+USB11) (9-pin+key)
J5 SATA0
Connector
J11 SATA1
Connector
J6 SATA2
Connector
J12 SATA3
Connector
J28
MiniPCI Connector (124-pin)
J3
DDR2 DIMM Connector (240-pin) Channel B Bank 1
J9
DDR2 DIMM Connector (240-pin) Channel B Bank 0
J17
DDR2 DIMM Connector (240-pin) Channel A Bank 1
J18
DDR2 DIMM Connector (240-pin) Channel A Bank 0
BAT1
Lithium Battery Socket
J35
Ext Battery Connector (option)
J21 Keyboard&Mouse
Connector
J7
Hardware Monitor Connector (20-pin)
J2
Extended Debug Port (XDP) Connector (reserved) [is located on the bottom side]
J27 CPU
Socket
J41
Connector for Temp. Sensor (factory fitted with Temperature Sensor)