beautypg.com

Kontron PCI-760 User Manual

Page 28

background image

9. Jumpers and Connectors Overview

26

PCI-760 – User’s Guide (V1.10)

9.1.3.10.

J16: Serial Port Connector COM2

The 10-pin box header is to be used with the supplied serial cable. This interface is RS232 (default) and can be

configured as RS422 or RS485 (BIOS Setup).

For RS422 and RS485 mode, please install the jumper caps (JP1 and JP2) to use the onboard

termination resistors (120ohm).

RS232 mode (default)

RS422 point-to-point mode:

The RX signal is always enabled via application software.

RS485 party line mode:

The RX signal is enabled when COM2 RTS is deasserted via application software.

The TX signal is enabled when COM2 RTS is asserted via application software.

COM2-pin assignment as RS232 (default):

J16: Boxed Header,

DIP 10-pin

RS232

(Pinning on the on-board header)

D-SUB

Connector

Pin #

Signal Name

1

DCD, Data carrier detect

2

DSR, Data set ready

3

RxD, Receive data

4

RTS, Request to send

5

TxXD, Transmit data

6

CTS, Clear to send

7

DTR, Data terminal ready

8

RI, Ring indicator

9 GND,

ground

1

9

2

10

COM2

10

12 V, fused

Pining on the

supplied cable

connector:

COM2 pin assignment as RS422:

J16: Boxed Header,

DIP 10-pin

RS422

(Pinning on the on-board header)

D-SUB

Connector

Pin #

Signal Name

1 NC

2 NC

3

RxD–, Receive data

4

RxD+, Receive data

5

TxD–, Transmit data

6

TxD+, Transmit data

7 NC

8 NC

9 GND,

ground

1

9

2

10

COM2

10

12 V fused

Pining on the

supplied cable

connector:

RXD–

TXD–

TXD+

RXD+