Kontron JRexplus-DC - Manual (Page 67)

KTD-S0008-F Page 62 Appendix A: System Resources
JRexplus-DC User's Guide
A.4 I/O Address Map
The I/O-port addresses of the JRexplus-DC are functionally identical to a standard PC/AT. All addresses not
mentioned in this table should be available. We recommend that you do not use I/O addresses below 0100h
with additional hardware for compatibility reasons even though they are available.
I/O Address Used for Available Comment
01F0h - 01F7h IDE Controller (P-ATA) No Note (1)
0278h - 027Fh Yes Possible address of LPT2
02E8h - 02EFh Yes Possible address of COM4
02F8h - 02FFh Yes Possible address of COM2
0376h IDE Controller (P-ATA) No Note (1)
0378h - 037Fh Parallel Port No Note (1)
03B0h - 03DFh Graphic Controller No
03E8h - 03EFh Yes Possible address of COM3
03F6h IDE Controller (P-ATA) No Note (1)
03F8h - 03FFh Serial Port 1 No Note (1)
0400h - 041Fh SMBus No Chipset
04D0h - 04D1h PIC Extension No Chipset
0500h - 053Fh GPIO No Chipset
0800h - 087Fh Power Management No Chipset
0A00h - 0A07h Hardware Monitor No Super-I/O
0A80h - 0A83h System Extension No CPLD
0CF8h - 0CFFh PCI Configuration No Chipset
C480h - C49Fh USB Controller No Chipset Note (1)
C800h - C81Fh USB Controller No Chipset Note (1)
C880h - C89Fh USB Controller No Chipset Note (1)
CC00h - CC1Fh USB Controller No Chipset Note (1)
CC80h - CC87h Graphics Controller No Chipset
DC80h - DC87h Gigabit Ethernet Controller No Onboard PCI Express device
EC80h - ECBFh Fast Ethernet Controller No Chipset Note (1)
FFA0h - FFAFh IDE Controller No Chipset Note (1)
Note: 1) If the Used for device is disabled in the BIOS Setup the corresponding address is free.