Kontron JRexplus-DC - Manual (Page 22)

KTD-S0008-F Page 17 Graphics Interface
JRexplus-DC User's Guide
7.5 Connecting a Flat Panel
To determine whether your flat panel is supported check the KONTRON website for panel lists. We regularly
update the list of panels that have been tested with the JRexplus-DC.
If you use one of those adapters supplied by KONTRON configuration is easy:
Check whether you have the correct adapter and cable for the panel you plan to use. Inspect
the cable for damages. Disconnect the power from your system.
Check jumper J2 for correct panel voltage.
Check jumper J5 for correct backlight voltage.
Check jumper J3 for correct backlight on/off polarity.
Connect the cable to the flat panel connector J4 on the JRexplus-DC and connect the other
end to your display.
Connect the backlight converter.
Supply power to your system.
If no image appears on your display connect a DVI monitor to the DVI connector.
If you still do not see improvement consider contacting the dealer for technical support.
7.6 Available Video Modes
The following list shows the video modes supported by the graphics controller with maximum frame buffer
size. When configured for saller frame buffers and/or using a flat panel on the JILI30 interface not all of
the video modes listed below may be available. Capability depends on system configuration and on display
capabilities. Different operating systems also may not support all listed modes by the available drivers.
Video Mode Type Characters/Pixels Colors
00h/01h Text 40 x 25 16
02h/03h Text 80 x 25 16
04h/05h Graphic 320 x 200 4
06h Graphic 640 x 200 2
07h Text 80 x 25 2
0Dh Graphic 320 x 200 16
0Eh Graphic 640 x 200 16
0Fh Graphic 640 x 350 2
10h Graphic 640 x 350 4
11h Graphic 640 x 480 2
12h Graphic 640 x 480 16
13h Graphic 320 x 200 256