Kontron KTA70M-mITX - Manual (Page 34)

KTD-N0861-B Page 27 Pin Connectors
KTA70M/mITX Users Guide
KTA70M/mITX Users Guide
7.4 USB4/5 Connector (J16)
USB Ports 4 and 5 are available via Pin Row connector type Foxconn HS1105F-RNP9 or similar.
The USB4 port is controlled by a set of OHCI and EHCI controllers (also shared by USB0/1/2).
The USB5 port is controlled by a set of OHCI and EHCI controllers (also shared by USB6/7/8/9).
The OHCI controllers support USB1.1, Full-Speed (12Mbps) and Low-Speed (1.5Mbps).
The EHCI controllers support USB2.0, High-Speed (480Mbps).
Header Pin Signal Description Type
1 5V/SB5V 5V (always) protected by separate 1A resettable fuse PWR
2 5V/SB5V 5V (always) protected by separate 1A resettable fuse PWR
3 USB4- Differential pair 4 -
DSIO-3.3
4 USB5- Differential pair 5 - DSIO-3.3
5 USB4+ Differential pair 4 + DSIO-3.3
6 USB4+ Differential pair 5 + DSIO-3.3
7 GND Ground PWR
8 GND Ground PWR
- (pin not mounted -Used for keying)
10 KEY NC
Notes: In order to meet the requirements of USB standard, the 5V input supply must be at least 5.00V.
The contacts for USB devices are protected and suitable to supply USB devices with a maximum input current of
1000mA.
Do not supply external USB devices with higher power dissipation through these pinsTo protect the external power
lines of peripheral devices make sure that
- the wires have the right diameter to withstand the maximum available current.
- to enclosure of the peripheral device fulfills the fire-protecting conditions of IEC/EN 60950.
Available cable kit:
PN 821401 Bracket Dual USB Cable