Kontron KTA70M-mITX - Manual (Page 25)

KTD-N0861-B Page 18 Rear IO Connectors
KTA70M/mITX Users Guide
KTA70M/mITX Users Guide
6.2 USB3.0 Connectors (USB10/USB11/USB12/USB13)(J15/J15/J14/J14)
The USB3.0 connectors are based on standard USB3.0 connectors type Lotes ABA-USB-104-K01 or similar.
Thease 4 USB3.0 ports are controlled by the xHCI controllers supporting USB3.0, USB2.0 and USB 1.1,
Super-Speed (5.0Gbps), High-Speed (480Mbps), Full-Speed (12Mbps) and Low-Speed (1.5Mbps)
USB Ports 10 and 11 (mounted on top of the DP#2 port):
Note Type Signal PIN Signal Type Note
DSIO-3.3 USB10- USB10+ DSIO-3.3
1 PWR 5V/SB5V 1 2 3 4 GND PWR
DSIO-3.3 RX10- 5 6 7 8 9 TX10+ DSIO-3.3
DSIO-3.3 RX10+ TX10- DSIO-3.3
PWR GND
DSIO-3.3 USB11- USB11+ DSIO-3.3
1 PWR 5V/SB5V 1 2 3 4 GND PWR
DSIO-3.3 RX11- 5 6 7 8 9 TX11+ DSIO-3.3
DSIO-3.3 RX11+ TX11- DSIO-3.3
PWR GND
USB Ports 12 and 13 (mounted on top of the DP#0 port):
Note Type Signal PIN Signal Type Note
DSIO-3.3 USB12- USB12+ DSIO-3.3
1 PWR 5V/SB5V 1 2 3 4 GND PWR
DSIO-3.3 RX12- 5 6 7 8 9 TX12+ DSIO-3.3
DSIO-3.3 RX12+ TX12- DSIO-3.3
PWR GND
DSIO-3.3 USB13- USB13+ DSIO-3.3
1 PWR 5V/SB5V 1 2 3 4 GND PWR
DSIO-3.3 RX13- 5 6 7 8 9 TX13+ DSIO-3.3
IO RX13+ TX13- DSIO-3.3
PWR GND
Signal Description
USB10+ USB10-
RX10+ RX10-
TX10+ TX10-
USB11+ USB11-
RX11+ RX11-
TX11+ TX11-
Differential pair works as Data/Address/Command Bus.
5V/SB5V
5V supply for external device. SB5V is supplied during powerdown to allow wakeup on
device activity. Protected by current limited power distribution switch,1A for each port.