Kontron AT8404 - Manual (Page 27)

Installation
14 AT8404 User Guide
www.kontron.com
2.3 Standard Removal Procedures
To remove the board proceed as follows:
1. Ensure that the safety requirements indicated in section 2.1. are observed.
2. Unscrew the front panel retaining screws.
3. Lift the notch of the lower handle and pull the handle with the notch away from the faceplate until you
feel a resistance. The blue LED starts blinking.
4. Wait until the blue LED is fully ON, this mean that the hot swap sequence is ready for board removal.
5. Disengage the board from the backplane by using both board ejection handles.
6. After disengaging the board from the backplane, pull the board out of the slot.
2.4 AMC Installation
To install an AMC proceed as follows:
1. Remove the AMC filler panel.
2. Carefully engage the AMC into the card guide. Push the AMC until it fully mates with its connector. Se-
cure the AMC handle to the locking position.
3. In normal condition, the blue LED shall turn ON as soon as the AMC is fully inserted. It will turn OFF at
the end of the hot swap sequence.
2.5 Software Installation
The AT8404 comes as a pre-installed system with all necessary OS, Filesystem, drivers and applications fac-
tory-installed with default configurations.
Updating the Software with new Operating System or applications or new versions is provided by a dedicated
update mechanism, which is described in Chapter 4.
WARNING
Care must be taken when applying the procedures below to ensure
that neither the AT8404 nor system boards are physically damaged by
the application of these procedures.