Kontron AT8404 - Manual (Page 117)

Software Description
104 AT8404 User Guide
www.kontron.com
CONFIG_ETH1_IP="dhcp"
CONFIG_ETH1_NETMASK=""
CONFIG_ETH1_BROADCAST=""
CONFIG_ETH1_VLAN_ID=""
CONFIG_ETH1_VCONFIG=""
CONFIG_ETH1_IFCONFIG=""
CONFIG_ETH1_4001_DEV="eth1.4001"
CONFIG_ETH1_4001_IP="dhcp"
CONFIG_ETH1_4001_NETMASK=""
CONFIG_ETH1_4001_BROADCAST=""
CONFIG_ETH1_4001_VLAN_ID="4001"
CONFIG_ETH1_4001_VCONFIG=""
CONFIG_ETH1_4001_IFCONFIG=""
CONFIG_ETH1_4002_DEV="eth1.4002"
CONFIG_ETH1_4002_IP="dhcp"
CONFIG_ETH1_4002_NETMASK=""
CONFIG_ETH1_4002_BROADCAST=""
CONFIG_ETH1_4002_VLAN_ID="4002"
CONFIG_ETH1_4002_VCONFIG=""
CONFIG_ETH1_4002_IFCONFIG=""
CONFIG_ETH1_4003_DEV="eth1.4003"
CONFIG_ETH1_4003_IP="dhcp"
CONFIG_ETH1_4003_NETMASK=""
CONFIG_ETH1_4003_BROADCAST=""
CONFIG_ETH1_4003_VLAN_ID="4003"
CONFIG_ETH1_4003_IFCONFIG=""
## set to DEBUG, TRACE, MINOR, MAJOR, CRITICAL
## for MCL_LOG generated messages
CONFIG_MCL_LOG_LEVEL="MINOR"
## set to yes to get MCL_LOG output on console as well
## otherwise it only goes to syslog
CONFIG_MCL_LOG_DEBUG_CONSOLE="yes"
# set to yes if FASTPATH shall drive pWD watchdog
# Otherwise, custom application may use pWD watchdog
# if this is yes, reload/reboot will do a graceful reboot
# otherwise, the fpmux/switchdrvr will just exit
# on reload/reset command
CONFIG_FASTPATH_WATCHDOG="yes"
# timeout in seconds for watchdog pWD
CONFIG_FASTPATH_WATCHDOG_TIMEOUT="5"
# update interval in seconds for watchdog pWD
CONFIG_FASTPATH_WATCHDOG_HEARTBEAT="1"
## if set to yes, pWD is enabled
CONFIG_WATCHDOG_PWD="yes"
## if set to yes, pOSWD is enabled
CONFIG_WATCHDOG_POSWD="yes"
## if set to YES include DHCP client ID in udhcpc queries
CONFIG_UDHCPC_CLIENTID="yes"
## this command is "eval"ed to get the client ID
## it must return a CLIENTID= string on stdout
CONFIG_UDHCPC_CLIENTID_COMMAND="/opt/kontron/bin/fru-query --dhcp-clientid"
## set to yes to enable script execution from UDHCPC
CONFIG_UDHCPC_SCRIPTEXEC="yes"