Kontron AT8404 - Manual (Page 107)

Software Description
94 AT8404 User Guide
www.kontron.com
3. Configure MUX (domain 1) for AMC B2
(Ethernet Fabric) #set board clock mux-bpl clk3b amcb2 tclkb
4. Set indirect clock descriptor (necessary for clock ekeying match finder)
(Ethernet Fabric) #set board clock receiver amcb2 tclkb enable sonet stratum3E 8kHz
5. Enable driver to backplane clock 3A and clock 3B
(Ethernet Fabric) #set board clock bpl clk3a enable
(Ethernet Fabric) #set board clock bpl clk3b enable
Note: The settings for the backplane driver are not automatically restored after power up.
(Ethernet Fabric) #show boardinfo clock amc
AMC clock Source/Target State Family Accuracy Frequency
----------- ----------------- --------- ---------- -------------- -----------
amcb1 tclka from: pll disable
amcb1 tclkb to : bpl enable sonet(1) stratum3E(50) 8kHz
amcb1 tclkc from: pll disable
amcb1 tclkd to : bpl disable
amcb2 tclka from: pll disable
amcb2 tclkb to : bpl enable sonet(1) stratum3E(50) 8kHz
amcb2 tclkc from: pll disable
amcb2 tclkd to : bpl disable
amcb3 tclka from: pll disable
amcb3 tclkb to : bpl disable
amcb3 tclkc from: pll disable
amcb3 tclkd to : bpl disable
amcb4 tclka from: pll disable
amcb4 tclkb to : bpl disable
amcb4 tclkc from: pll disable
amcb4 tclkd to : bpl disable
(Ethernet Fabric) #show boardinfo clock bpl
BPL clock Driver Source
--------- -------- -----------
clk1a disabled amcb1 tclkb
clk1b disabled amcb1 tclkb
clk2a disabled amcb1 tclkb
clk2b disabled amcb1 tclkb
clk3a enabled amcb1 tclkb
clk3b enabled amcb2 tclkb
4.5.3.2 Example 2
Configure clock TCLKC (8kHz) to AMCB2 sourced by backplane CLK1A (PLL bypass).
1. Configure MUX (domain 0)
(Ethernet Fabric) #set board clock mux-amc amcb2 tclkc bpl clk1a
2. Set indirect clock descriptor (necessary for clock ekeying match finder)
(Ethernet Fabric) #set board clock source amcb2 tclkc enable sonet stratum3E 8kHz