Kontron CP6002 uEFI BIOS - Manual (Page 66)

The uEFI Shell CP6002 uEFI BIOS
Page 60 ID 1039-1612, Rev. 2.0
USAGE: Change IRQ
kipmi irq 10
Show IRQ configuration
kipmi irq
SETTINGS:
fru []:
Displays FRU data
Options:
FRU Device ID:
Numeric FRU Device ID. 0 is assumed if FRU
Device ID is omitted. 0 is the baseboard’s own FRU Device ID.
info:
Display IPMI firmware information
ipmb:
Displays IPMB bus settings
ipmb dual-ported:
Switch IPMB bus to dual-ported mode
ipmb single-ported:
Switch IPMB bus to single-ported mode
irq :
Display/Set the IRQ number of the KCS interface
Options:
0:
KCS uses no IRQ
10:
KCS uses IRQ 10
11:
KCS uses IRQ 11
The board must be reset for the settings to apply.
mode :
Display/Set the IPMI controller operating mode
Options:
bmc:
IPMI controller operates in BMC mode
smc:
IPMI controller operates in SMC mode
net:
Set Serial-over-LAN parameters
sel:
Display system event log
sensor list|read:
Show board sensor data
Options:
list:
Display an overview of all available board sensors
read:
Display specific sensor data
raw [ <...>]:
Execute raw IPMI command
Syntax:
raw [NetFn] [LUN] [COMMAND] ...
Execute rawSendMessage command:
COMMAND / RESPONSE:
Shell> kipmi rawsendmessage 0x20 0x00 0x06 0x00 0x01
“kipmi rawsendmessage” alone returns error message and help on
available parameters
kipmi