Kontron CP6002 uEFI BIOS - Manual (Page 42)

Boot Setup CP6002 uEFI BIOS
Page 36 ID 1039-1612, Rev. 2.0
4.1.2 uEFI Boot
This function is used to enable or disable uEFI boot from disks.
Default setting: Enabled
4.1.3 Bootup NumLock State
This function is used to set the state of the keyboard’s numlock function after POST.
Default setting: Off
4.1.4 CSM16 Module Version
This function provides display-only information concerning the CSM Module and is intended for
internal use only.
4.1.5 GateA20 Active
This function is used to enable or disable GateA20.
Default setting: Upon Request
4.1.6 Option ROM Messages
This function is used to control the messages of the loaded PCI option ROMs.
Default setting: Force BIOS
SETTING DESCRIPTION
Disabled Use this setting to prevent the system from booting native uEFI operating systems from
disks.
Enabled Use this setting to enable booting of native uEFI operating systems from disks, if present,
and in boot order.
SETTING DESCRIPTION
On Use this setting to switch on the keyboard’s numlock function after POST.
Off Use this setting to switch off the keyboard’s numlock function after POST.
SETTING DESCRIPTION
Upon Request Use this setting to disable GA20 in the uEFI BIOS.
Always Use this setting to prevent the system from disabling GA20.
SETTING DESCRIPTION
Force BIOS Use this setting to force to a BIOS-compatible output. This will show the option ROM mes-
sages.
Keep Current Use this setting to keep the current video mode. This will suppress option ROM messages.
Option ROMs requiring interactive inputs may not work properly in this mode.