Kontron CP6002 uEFI BIOS - Manual (Page 60)

The uEFI Shell CP6002 uEFI BIOS
Page 54 ID 1039-1612, Rev. 2.0
7.2.3 kboardinfo uEFI Shell Command
SETTINGS
wr_prot_eeprom:
System EEPROM write protection
[disabled]:
Do not write protect the system EEPROM
enabled:
System EEPROM is write-protected after POST
wr_prot_spi:
EFI SPI flash write protection
[disabled]:
Do not write protect the EFI SPI flash
enabled:
The EFI SPI flash is write-protected after POST
CStates:
Enable/Disable all CPU CStates ( [enabled] )
C1eState:
Enable/Disable CPU C1eState ( [enabled] )
C3State:
Enable/Disable CPU C3State ( [disabled] )
C6State:
Enable/Disable CPU C6State ( [disabled] )
PciCfgDelay:
Set Delay for PCI Configuration Cycle
[disabled]:
No delay for PCI Configuration Cycle
1s, 2s, 3s, 4s or 5s:
1 to 5 seconds delay possible
VgaInterrupt:
Enable/Disable VGA interrupt generation (assertion
of IGD interrupt signal) ( [disabled] )
kboardinfo
FUNCTION: Show board identification data
SYNTAX:
kboardinfo
DESCRIPTION: The kboardinfo command shows a summary of board-specific
identification data. It is especially useful for support queries because it
contains this data in a concentrated form.
kboardconfig