ETS-Lindgren HI-1710 Microwave Measurement System (Archived) - Manual (Page 38)

HI n 1710 Manual Page — 33
Z The Z command zeros the instrument. In addition,
when the zero command is received and the RS-232
output is in mode 2 (the default mode), a formatted
output message is sent through the serial port and
the instrument is zeroed. The formatted message
transmits the RF reading only when the front panel
PEAK HOLD mode is ON. Refer to the RS-232 mode
descriptions earlier in this section and to the M
command for more information.
Archived 4/2/10