ETS-Lindgren HI-1710 Microwave Measurement System (Archived) - Manual (Page 31)

Page — 26 HI n 1710 Manual
frequency.
Example:120.50
Filter 1Two stages Cutoff
frequency 0.50 Hz.
S4: X.XXX Bias voltage.
S5: X.XXX Offset - milliwatts.
S6: X.XX Stim test value (X.XXX in four
digit mode).
S7: X.XXX 4 volt power supply level.
X.XXX 5 volt power supply level.
X.XXX 8 volt power supply level.
X.XXX -8 volt power supply level.
Note: A carriage return (CR) is sent after
each value. A line feed (LF) is not sent.
S8: X.XX RF reading (X.XXX in four
digit mode).
Error Messages
In any mode, an invalid command will produce an error
message ENTRY ERROR -- PLEASE RETRY. In addition,
the following error messages will be transmitted if, during
the self-test, an out of specification condition is detected.
Message format:
"MESSAGE" RDG. IS --> XXXX RDG.. SHOULD BE --
> XXXX
Archived 4/2/10