ETS-Lindgren HI-1710 Microwave Measurement System (Archived) - Manual (Page 37)

Page — 32 HI n 1710 Manual
FILTER 1 / 2 POLES 0.50 Hz CUTOFF
FILTER 2 / 2 POLES 2.00 Hz CUTOFF
FILTER 3 / 8 POLES 0.45 Hz CUTOFF
FILTER 4 / 8 POLES 0.90 Hz CUTOFF
4 Send Bias Voltage - The Probe Bias Voltage is
sent in the form: BIAS --- X.XXX
5 Send Offset - The Probe Offset Voltage is sent
in the form: OFFSET -- X.XXX
6 Send Stim Value - The Stimulus signal is
applied to the probe circuitry and the resulting
output value displayed in the form: STIM ----
X.XX
7 Send Power Supply Voltages - The four internal
power supply voltages are sent in the form:
4 VOLTS - X.XXX
5 VOLTS - X.XXX
8 VOLTS - X.XXX
-8 VOLT - X.XXX
8 Send RF Reading - The RF reading is sent in the
form X.XX
ST Runs self-test routine. After completion of the
self-test, the HI-1710 sends SELF-TEST PASSED
message.
T Change Alarm set point. The form of the command
is T# where # is a number from 0 to 9999. The
number is the alarm set point in microwatts/square
centimeter, eg., 5000 is 5.0 mW/cm
2 , 5 is .005
mW/cm 2 , etc.
Archived 4/2/10