ETS-Lindgren HI-1710 Microwave Measurement System (Archived) - Manual (Page 35)

Page — 30 HI n 1710 Manual
sequence. This command has the same effect as
turning the instrument off then on again.
M The mode command sets the output format of the
RS-232 port. The command is of the form M#
where # is 0,1, 2, or 3. The modes are described
earlier in this section.
0 Print mode OFF
1 Prints (sends) continuous readings to the
RS-232 serial port.
2 Prints summary ticket (outputs formatted data
to the RS-232 serial port). This is the default
mode.
3 Does not print summary ticket when instrument
is zeroed. Sends summary messages designed
for easier reading by an external control
computer.
P The P command selects the Peak Hold mode. The
command is of the form P# where # is 0 or 1. P0
sets the Peak Hold mode to OFF; P1 sets the mode
to ON. The default mode is OFF (P0).
Q The Q command turns the audible alarm off and on.
The command is of the form Q# where # is 0 or 1.
Q0 turns the alarm off; Q1 turns the alarm on. The
default mode is ON (Q1)
Archived 4/2/10