ETS-Lindgren HI-1710 Microwave Measurement System (Archived) - Manual (Page 30)

HI n 1710 Manual Page — 25
MODE 3 Mode 3 changes the output format of the
status messages (S0-S8). The transmitted
messages are shortened for easier adaptation to
a computer interface program. The zero
command does not transmit a formatted report
as in mode 2. In mode 3 the transmitted status
messages end with only a carriage return (CR)
terminator. In modes 0,1, and 2, the messages
end with a carriage return and a line feed
(CR/LF).
The status message format for mode 3 is as
follows:
S0: XXXXX First digit = 3 or 4 for number
of digits displayed and
transmitted.
Second digit = 0 or 1 for
Auto-Range off or on.
Third digit = 0 or 1 for Peak
Hold off or on.
Fourth digit = 0 or 1 for in
range or over range.
Fifth digit = 0, 1, 2, or 3 for
operating mode.
S1: X.XX Alarm trigger point (X.XXX
when in four digit mode).
S2: X Range number 1-4.
S3: XXX.XX First digit = filter number (1-
4)
Second digit = number of
filter stages.
Digits 3-6 = filter cutoff
Archived 4/2/10