Elecraft XG3 RF - Manual (Page 13)

13
Morse/RTTY Memory Examples
Use the XG3 Utility’s Command Tester (far right tab) to enter these commands:
WM,^0de_w1aw:10^1:10^2:10*$60#;
Changes the level to 0 dBm, then sends ‘de w1aw’, sends carrier at 0 dBm for 10 seconds, then
changes the level to -33 dBm, sends carrier for 10 seconds, changes level to -73 dBm, sends carrier for 10
seconds, sends SK, pauses silent for 60 seconds and repeats indefinitely.
WM,{RYRYRYRYRYRY~05#;
Changes to RTTY output mode, sends RY 6 times, then sends diddles for 5 seconds and repeats
indefinitely.
WM,{\n\rRIG_IS_XG3$03}de_w1aw#;
Changes to RTTY and sends LF,CR then “RIG_IS_XG3” , then waits 3 seconds, changes to CW and sends
“de w1aw” and then repeats.
WM,{QTH_IS_APTOS_CA\#95001_#;
Here is an example of using the ‘\’ character to embed a # in the message, while the # on the end signals
repeat message.
WM,[13de_w1aw:03[20de_w1aw:03[30de_w1aw:03[40de_w1aw:03#;
Changes WPM to 13 and sends ‘de w1aw’ followed by 5 seconds of carrier, then changes to 20 wpm and
sends the same message, then 5 seconds of carrier, then changes to 30 wpm, …… then 40 wpm.
Set up the PF1 key for Morse memory sending:
PF,01,01; configure PF1 to send Morse memory.
To play the memory, either hold down the Band+/PF1 key or send S,01; over the serial port.