Elecraft XG3 RF - Manual (Page 12)

12
WM[,character string…..]
programs the Morse/RTTY Memory
Fills the Morse Memory with the string following the command. Up to 60 characters total may be entered.
Entering WM without any arguments displays the current contents.
Send WM,de_w1aw_*;
XG3: nothing
Send: WM;
XG3:
WM,de_w1aw_*;
W[,character,string,…..]
sends the character string or Morse Memory
The character string will be sent out. If no character string is specified, the contents of the Morse memory
will be sent.
Send W,rig_is_xg3_de_W1AW_73_*;
XG3: nothing
Send the Morse memory:
Send: W;
XG3: nothing
RT,character_string,….
immediately sends the character string using RTTY
To embed a space, use the ‘_’ (underscore) character, \n for LF, \r for CR etc.
Send: RT,\r\n_rig_is_xg3_de_W1AW_73;
XG3: nothing
WP[,wpm]
sets/views the Morse word per minute rate (wpm)
The XG3 can send Morse code at a rate of between roughly 5 and 50 words per minute (wpm).
Send WP,25;
XG3: nothing
Send: WP;
XG3:
WP,25;
PF,01[,mode]
sets/views the programmable function mode
PF1 can run either a programmed sweep (mode=00) or send the Morse code memory (mode=01).
Set PF1 to send the Morse memory
Send: PF,01,01;
XG3: nothing
Send PF,01;
XG3: PF,01,01;