Elecraft K144XV Manual - Manual (Page 14)

14
Lift the top cover off of the K144XV module and connect the cables as follows (See Figure 7). The top
cover is supplied fitted but not screwed onto the module.
CAUTION
DO NOT touch the small red coils on the K144XV pc board. Doing so will disturb the
alignment and compromise the performance of your K144XV.
Connect the cable from the rear panel ANT3 connector.
Connect the marked cable from the KXV3A module to the IF IN connector on the K144XV board.
Connect the remaining cable from the KXV3A to the IF OUT connector on the K144XV board.
NOTE: The other connections indicated on the label have no pc board connectors at this
time. They are provided for future use.
Figure 7. Mounting the K144XV Module in the K3.