Elecraft KX3 Assembly Manual - Manual (Page 35)

33
Final Assembly
Turn the bottom cover assembly over and install both tilt feet as shown in Figure 48. Do not tighten the
thumb screw until the top cover assembly has been fitted. Without the thickness of the side panels on the top
cover the screw will strike the RF pc board.
Figure 48. Installing the Tilt Feet.
Fit the top and bottom covers together as shown in Figure 49. Be sure the battery cable is out of the way
and not trapped between the covers. It will be installed later. Secure the covers with four thumb screws. Two of
the screws are already in place holding the rear feet.
Figure 49. Test Fitting the Top and Bottom Covers Together.