Elecraft KX3 Assembly Manual - Manual (Page 11)

9
Inspect the inside surface of the side panels. Remove any masking tape and ensure the metal is clean in the
areas shown in Figure 6.
Figure 6. Side Panels Clean Contact Areas.
NOTE: Areas of the bottom cover also need to be clean. If you wish to do all the metal cleaning at
once, turn to pg 20 before returning here to continue the assembly.
Locate the speaker and dress the cable attached to it as shown in Figure 7. This is important to ensure the
speaker is oriented correctly when you install it.
Figure 7. Dressing the Speaker Cable.