Elecraft KX3 Assembly Manual - Manual (Page 24)

22
Mount two of the four rubber feet on the bottom cover using nylon screws as shown in Figure 29. First
clear any paint out of the threads with one of the black 4-40 thumbscrews. Orient the feet so that the heads of the
screws are recessed in the large openings.
Figure 29. Mounting Rubber Feet on Bottom Cover.
On the inside of the bottom cover, trim all four nylon screws flush with the cover.
Use the black thumb screw to clear any paint from the threaded holes in the tilt legs (see Figure 30).
Slide the remaining two rubber feet onto the tilt legs as shown in Figure 30. The feet are held in place by
friction. Be sure you work the feet all the way onto the legs as shown.
Figure 30. Preparing Tilt Legs for Installation – Part 1.