Dynojet 250iX: Upgrade Installation Guide - Manual (Page 54)

Model 200iX/250iX Upgrade Installation Guide
A P P E N D I X B
Ramp Installation
B-4
7 Remove the four existing 1/4-20 x 5/8-inch screws from the dyno ramp as shown
in Figure B-3.
8 Remove the two existing 1/4-20 x 5/8-inch screws from the iX ramp as shown in
Figure B-3.
9 Secure the ramp tie-down to the dyno ramp using the four screws removed
earlier.
10 Secure the ramp tie-down to the iX ramp using the two screws removed earlier.
11 Place the ramp cover as shown in Figure B-3.
Note: The ramp cover provides easy access to the air pump filter assembly.
12 Route the air fuel hoses through the large holes in the ramp cover.
Figure B-3: Securing the Ramp Tie-Down
ramp tie-down
ramp cover