Dynojet 250iX: Upgrade Installation Guide - Manual (Page 36)

Model 200iX/250iX Upgrade Installation Guide
C H A P T E R 1
Ground Hook Installation
1-28
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
GROUND HOOK INSTALLATION
Use the following instructions to install the ground hooks.
You will need the following parts:
• 10111 Ground Hook/D-Ring (4)
• 10112 D-Ring Bracket (4)
• 36932100 Washer, 3/8”, Splitlock, Steel (8)
• 37513200 Anchor, Redhead, 3/8" (8)
• DM150-002-007 Washer, 5/16", Flat (8)
• DM150-019-012 Bolt, 3/8-16 x 1”, Hex (8)
1 Mark the ground hook placement as shown in Figure 1-24. Two additional ground
hooks are included for installation in front of the dyno; placement will vary
depending on dyno application.
2 Using the ground hook as a template, mark and drill each hole needed to secure
the ground hooks to the floor.
3 Install the Red Head anchors. Refer to Appendix A for installation instructions.
4 Secure each ground hook to the floor using two 3/8-16 x 1-inch hex bolts, two
5/16-inch flat washers, and two 3/8” lock washers.
Figure 1-24: Ground Hook Placement