Dynojet 250iX: Upgrade Installation Guide - Manual (Page 27)

M O D E L 2 0 0 I X / 2 5 0 I X U P G R A D E
Bulkheads and Covers
Version 1 Model 200iX/250iX Upgrade Installation Guide
1-19
5 Secure the dyno top side panel to the bulkheads using the five screws removed
earlier.
6 Secure the drum side cover to the drum module using the eight 1/4-20 x 5/8-inch
button-head screws removed earlier.
Figure 1-15: Securing the Dyno Top Side Panel and Drum Side Cover
7 Place the drum safety cover over the drum. This cover has two pins to keep it in
place.
Risk of injury. Never run a motorcycle on the dyno without this cover in place.
Figure 1-16: Installing the Drum Safety Cover
dyno top side
panel
drum side cover
drum safety
cover