Dynojet 250iX: Upgrade Installation Guide - Manual (Page 33)

M O D E L 2 0 0 I X / 2 5 0 I X U P G R A D E
Tie-Down Installation
Version 1 Model 200iX/250iX Upgrade Installation Guide
1-25
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TIE-DOWN INSTALLATION
You will need the following parts:
• 36582034 Bolt, 3/8-16 x 1.25", Button-head, Flange (8)
• 61300009 Tie-Down (2)
1 Install the tie-downs on the right side of the dyno using four 3/8-16 x 1.25-inch
button-head flange screws.
2 Place the tie-down on the left side of the dyno, but do not secure.
Note: Do not secure the tie-down used with the monitor arm until the monitor
arm is in place. Refer to step 1 on page 1-26 for more information.
Figure 1-21: Installing the Tie-Downs
tie-down under
monitor support
tie-down on right
side of dyno