Monitor stand and blowers installation – Dynojet 250iX: Upgrade Installation Guide User Manual
Page 34
Model 200iX/250iX Upgrade Installation Guide
C H A P T E R 1
Monitor Stand and Blowers Installation
1-26
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MONITOR STAND AND BLOWERS INSTALLATION
You will need the following parts:
• 21600015
Lower Blower Arm (2)
• 26215220
Washer 1.5 x .38 ID x .187 THK (2)
• 26215521
Washer 1.87 x 1.25 ID x .25 THK (2)
• 35712991
Clamp Lever, 3/8-16 x 3/4" (2)
• 76950317
Blower Extension Cord
1
Secure the monitor support to the dyno using the four screws removed earlier.
Note: Make sure the tie-down in sandwiched in between the dyno panel and the
monitor support base.
2
Replace the monitor arms, washers, and tray.
Figure 1-22: Installing the Monitor Stand
monitor
support
tie-down under
monitor support
washer
tray
arms
washers