Dynojet 150: Eddy Current Brake - Manual (Page 9)

E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Preparation
Version 8 Eddy Current Brake Installation Guide
1-3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PREPARATION
This section describes how to unpack the eddy current brake and remove the hood
from your dyno.
U NPACKING THE E DDY C URRENT B RAKE
1 Remove the top and sides of the crate.
2 If you ordered a hood upgrade, remove the new hood from the crate.
3 Remove the four bolts securing the eddy current brake cover and set aside.
4 Remove the two bolts securing the hood clamps to the brake and set aside.
5 Remove the hardware box from the crate and verify the hardware box contents.
Refer to the parts list on page 1-2.
Figure 1-1: Remove the Brake Cover and Hood Keepers
brake cover
hood clamps