Dynojet 150: Eddy Current Brake - Manual (Page 40)

Eddy Current Brake Installation Guide
A P P E N D I X B
B-2
2 If not already removed, remove the four bolts in the dyno frame from the
positions shown in Figure B-2.
3 Remove the four nuts and washers from the positions shown in Figure B-2 leaving
the bolts in place.
Figure B-2: High Inertia Drum—Remove Nuts and Washers
4 Slip the connecting arms over the four existing bolts on the dyno frame and
loosely attach the arms using the four washers and nuts removed earlier. These
nuts need to remain loose in order to align the brake
5 Loosely attach the connecting arms using the four 3/8-inch bolts and 3/8-inch
washers removed earlier. These bolts need to remain loose in order to align the
brake
6 Continue with “Aligning the Eddy Current Brake” on page 1-13.
Figure B-3: High Inertia Drum—Connect Brake
remove bolts
do not remove
remove nuts
and washers
remove nuts
and washers
remove bolts