Dynojet 150: Eddy Current Brake - Manual (Page 32)

Eddy Current Brake Installation Guide
C H A P T E R 1
Theta Controller
1-26
C HANGING THE I NPUT P OWER C ABLE P LUG
If the input power cable is not provided with a power plug, you must install the
correct power plug for your country. The input power cable plug must connect to a
properly grounded outlet and be easily accessible so that it may be disconnected. Do
not wire the input power cable directly into the power panel. Refer to Figure 1-34 for
individual wire descriptions.
Note: The eddy current brake is set up to run on 120 volts/20 amps/60 Hz for
North America and 240 volts/10 amps/50 Hz for Europe/Australia.
Note: The voltage source and power plug must be capable of handling a
minimum of 20 amps for North America and 10 amps for Europe/Australia.
Figure 1-34: Theta Controller—Input Power Cable Plug
V ERIFYING THE E DDY C URRENT B RAKE W IRING C ONFIGURATION
Refer to Figure 1-35 to determine whether the eddy current brake is currently wired
for 120 or 240 volt operation.
Figure 1-35: Theta Controller —Eddy Current Brake Wiring
neutral—clear or white
insulation wire
hot—black insulation wire
ground—bare or
green wire
120 volt wiring, North America 240 volt wiring, Europe/Australia