Dynojet 150: Eddy Current Brake - Manual (Page 14)

Eddy Current Brake Installation Guide
C H A P T E R 1
Air Brake and Manual Brake Removal
1-8
R EMOVING THE B RAKE C ALIPER A SSEMBLY
1 Remove the four bolts and washers that secure the caliper assembly.
2 Loosen the brake pads and remove the assembly.
Note: Do not put the bolts back into the dyno frame. The holes will be used to
mount the eddy current brake to the dyno.
3 Loosen the set screw above the keyway in the drum axle using a 3/16-inch allen
wrench.
4 Remove the three 5/16-inch bolts in the lock collar and insert these bolts in the
three threaded holes in the lock collar. Tighten the bolts until the collar comes
loose.
5 Slide the rotor and lock collar off the drum axle and remove the key.
Figure 1-10: Remove the Brake Caliper Assembly
caliper assembly
key way
lock collar