Figure 1-6: air brake—remove the springs, Figure 1-7: air brake—remove the master cylinder – Dynojet 150: Eddy Current Brake User Manual
Page 12
Eddy Current Brake Installation Guide
C H A P T E R 1
Air Brake and Manual Brake Removal
1-6
3
Remove the jam nuts, adjuster nuts, retainers, and springs.
The springs are compressed. Use caution when removing the springs.
4
Disconnect the brake line from the master cylinder to the caliper.
Note: Make sure you have disconnected all air lines and released the tension in
the springs before disconnecting the brake line.
Figure 1-6: Air Brake—Remove the Springs
5
Remove the two bolts securing the master cylinder to the air cylinder using a
3/16-inch allen wrench. Remove the master cylinder.
Figure 1-7: Air Brake—Remove the Master Cylinder
spring
retainer
adjuster nut
jam nut
cut away view of dyno
side panel
bolts
master cylinder
This manual is related to the following products: