Dynojet 150: Eddy Current Brake - Manual (Page 27)

E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Theta Controller
Version 8 Eddy Current Brake Installation Guide
1-21
5 Route the input power cable under and out the front of the dyno.
6 Insert the smaller rubber grommet as shown in Figure 1-27.
7 Route the temperature sensor cable from the eddy current brake through the
dyno to the Breakout board.
8 Route the control cable from the Theta Controller to the Breakout board.
Figure 1-27: Theta Controller—Routing the Cables on Left Side
temp sensor
cable
brake power
cable
control cable
input power
cable
Breakout board
small
grommet
large
grommet