Dynojet 150: Eddy Current Brake - Manual (Page 25)

E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Theta Controller
Version 8 Eddy Current Brake Installation Guide
1-19
R IGHT S IDE I NSTALLATION
1 Locate the template for right side installations included with the control box.
This template can also be found in Appendix D.
2 Place the template on the dyno. Line the template up using the existing hole and
the bottom lip of the dyno frame.
3 Mark and drill the three mounting holes to 3/16-inch (5 mm).
Note: Make sure no metal chips come in contact with the electrical components.
Figure 1-25: Theta Controller—Drill Mounting Holes on Right Side
existing hole
template
Breakout board