Installing the theta controller—right side, Installing the theta controller—right side -22 – Dynojet 150: Eddy Current Brake User Manual
Page 28
Eddy Current Brake Installation Guide
C H A P T E R 1
Theta Controller
1-22
I
NSTALLING
THE
T
HETA
C
ONTROLLER
—R
IGHT
S
IDE
1
Install the Theta Controller using four No. 8 screws and washers. The screws will
mount from the inside of the dyno.
Figure 1-28: Theta Controller—Install on Right Side
2
Attach the input power cable to the Theta Controller and route the input power
cable along the side of the dyno.
3
Attach the eddy current brake cable to the Theta Controller.
Note: Make sure the brake power cable is clear of the coupler.
4
Attach the temperature sensor cable from the eddy current brake to the Breakout
board.
5
Attach the control cable from the Theta Controller to the Breakout board.
Figure 1-29: Theta Controller—Routing the Cables on Right Side
input power cable
brake power
cable
temp sensor cable
control cable
Breakout board