Canon EOS 7 - Manual (Page 96)

Troubleshooting Guide
If there is a problem, try to resolve it by referring to this Troubleshooting
Guide. If the problem still persists, take the camera to your nearest Canon
Service Center.
Reference
Nothing is
displayed on the
LCD panel.
The batteries are exhausted.
•• Replace the batteries with new ones, (-»page 18, 19)
The batteries have been installed incorrectly.
>■ Install the batteries correctly, (-»page 18)
The picture looks
blurred.
The lens focus mode is set to (or ).
• Set the lens focus mode to (or
).
(-»page 20)
There was camera shake when the picture was taken.
► Hold the camera steady or use a faster shutter speed,
(^page 22)
The shutter does
not work.
The <(§!> icon blinks on the LCD panel.
>■ Take out the film and load it correctly, (-»page 23)
The < 0 > icon blinks on the LCD panel.
Replace the batteries with new ones, (-»page 18)
The <(§!> icon blinks while the rewound film is still in the
camera.
■■ Replace with a new roll of film, (-»page 23)
The in-focus indicator in the viewfinder blinks and focus
cannot be achieved.
•• Select another focusing point, (-^page 45) If focus still
cannot be achieved, focus manually, (-»page 48)
The < ¡1 > icon
blinks on the LCD
panel. The battery level is very low,
« Replace the batteries with new ones, (^page 18)
A misoperation has occurred.
• Press the shutter button halfway, (^page 22)
•• Remove and reload the batteries, (-»page 19) If the < Q >
icon stops blinking, picture-taking is possible.
If it is still blinking, consult your nearest Canon Service
Center.
96