Canon EOS 7 - Manual (Page 72)

I Wireless Remote Control
Remote Controller RC-1 (sold separately) enables wireless remote control
operation in all the picture-taking modes.
Turn the film advance mode lever
to .
► The < I > icon appears on the LCD panel.
Take the picture via remote control.
• Point the Remote Controller RC-1's signal emitter
toward the camera’s remote control sensor and
press the Send button. Wireless remote control
works within 5 meters from the camera.
• Remote shutter release is indicated as follows:
2-sec. delay: The red-eye reduction lamp lights
for 2 sec., then the picture is taken.
Immediate shutter release: When the picture is
taken, the red-eye reduction lamp flashes.
W Certain types of fluorescent lights might cause the remote control operation to work
improperly. Place the camera away from any fluorescent lights as much as possible.
0 If you set the film advance mode lever to and do nothing for four minutes, the
wireless remote control mode will be canceled automatically to save battery power.
To set It again, press the shutter button halfway. The < | > icon displayed on the
LCD panel indicates that the wireless remote control mode can be used.
Using the Remote Switch
The Remote Switch RS-60E3 (sold separately) can be used in all the
picture-taking modes.
Connect the Remote Switch’s plug to
the camera’s remote control terminal.
Press the release button to take the
picture.