General safety precautions, Operational pre Page 21
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up Coolscan
Chapter 2
Page 14
5. When mounting Coolscan into the Macintosh (LS-10 only), be especially mind
ful to eliminate electrostatic discharge, as it can damage the scanner.
Electrostatic discharge will damage the scanner if you touch its SCSI connector
pins. Do
not
touch the pins.
General Safety Precautions
Always power off Coolscan and/or remove the power cord from the AC
source when any one of the following occurs:
1. The AC power cord (LS-lOE only) or 4-pin DC power plug (LS-10 only)
becomes damaged.
2. Any liquids are spilled into the scanner.
3. The scanner is exposed to excessive moisture.
4. The housing of the scanner is opened or has become damaged (LS-lOE only).
5. You suspect the scanner is not functioning properly.
6. Something unusual occurs, such as abnormal noise, odor, or smoke. In this case,
bting your Coolscan to the dealer where it was purchased or to an authorized Nikon
repair facility.
Operational Pre
Never power on the scanner while the film strip holder is in the scanner slot.
Doing so will interfere with the scanner’s normal startup calibration procedure,
resulting in incorrect color capture while scanning, and possible SCSI errors.
2. Do not attempt to insert slide mounts into Coolscan that are over 3mm thick.
Remount the film into an apptopriate holdet.
3. Do not attempt to insert slide mounts into Coolscan that are not flat. Remount
the film into an appropriate holdet.
4. Do not force a slide or the film strip holder into the Coolscan film slot. A
smooth gliding action should be used during both insertion and removal.
5. Do not attempt to remove or reposition the slide or film strip holder in the
Coolscan film slot during the scanning process.
Nikon
Coolscan Installation Guide for Macintosh