Nikon LS-10 Installation Guide for Macintosh - Manual (Page 18)

Chapter 2 Setting Up Coolsran
Proper Placement
The following guidelines and precautions should be adhered to when deciding on
placement of your LS-lOE:
1. Place Coolscan near the computer so that the maximum suggested SCSI cable
length (6 feet) is not exceeded.
2. Place the scanner so that it is easy to reach.
3. Coolscan should be placed on a flat, stable surface, free from vibration.
4. Keep the scanner away from damaging liquids by locating it away from sinks,
coffee pots, etc.
5. Protect Coolscan from dampness, high humidity, and excessive dust or smoke.
Dust and smoke, in particular, can cause undesirable effects on the scanner’s optical
systems, requiring extensive cleaning and maintenance to correct.
6. Avoid locations where a sudden change in temperature might cause condensation
inside the scanner.
7. Protect the front of the scanner from direct sunlight or bright lights.
8. Avoid places with extremely hot or cold temperatures (below 10 degrees Celsius
or above 35 degrees Celsius).
9. Avoid placing Coolscan near heat sources.
10. Avoid any physical shocks to the scanner. Do not store the unit where it will be
subject to vibration.
11. Avoid placing Coolscan too close to other peripherals, and make sure there is
sufficient air circulation on all sides of the scanner.
Transporting Coolscan
The following guidelines and precautions should be adhered to when transporting
your Coolscan:
1. Always use the original packaging materials.
2. If the original packaging materials are unavailable, use appropriate packaging
Nikon Coolscan Installation Guide for Macintosh Page 11