Sony XD-DV300 - Manual (Page 48)

SPECIFICATIONS
Power supply
Power consumption
Weight
External dimensions
Signal format
Supported discs
S2 video output
Video output
120VAC, 60 Hz
29 W
5.3 kg (11.66 lbs)
430 X 105 X 360 mm (w x h x d)
(17x 4’/4 X 1 4V4 inches)
NTSC
DVD video discs
12 cm (single-sided single-layer, single­
sided double-layer, double-sided-double
layer)
8 cm (single-sided single-layer, single­
sided double-layer, double-sided-double
layer)
Compact discs (CD-DA, video CD)
12 cm and 8 cm discs
Y output: 1 Vp-p (75 ohms, sync negative)
C output: 0.286 Vp-p
Video composit output
1 Vp-p (75 ohms, sync negative)
Two RCA jacks
Video compornent output
Y output: 1 Vp-p (75 ohms, sync negative)
P b ,P r output: 0.7 Vp-p (75 ohms)
DOWN MIXING AUDIO OUT connector
100 mV RMS(1 kHz,-20 dB)
2 RCA jacks (L/R)
Fiber optical connector (lEC 958)
Audio output characteristics
Frequency range:
CD / VCD: 20 Hz to 20 kHz
DVD: 4 Hz to 22 kHz (48 kHz sampling)
4 Hz to 44 kHz (96 kHz sampling)
Wow and flutter: unmeasurable
5’C to 35"C(41Tto95°F)
Video and audio connection cables (1 set).
Remote control (1)
Batteries (R6, size AA) (2)
Audio output
Operating conditions
Accessories
NOTE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi­
cations. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
CAUTION
Modifications or adjustments to this product, which are not
expressly approved by the manufacturer, may void the user's right
or authority to operate this product.
Manufactured under license from Dolby Laboratories Licensing
Corporation.
“Dolby" and the double-D symbol are trademarks of Dolby
Laboratories Licensing Corporations
Manufactured under license from Digital Theater Systems, Ino.
US Pat. No. 5,451,942 and other worldwide patents issued and
pending. “DTS” and “DTS Digital Surround” are trademarks of
Digital Theater Systems, Inc. ©1996 Digital Theater systems,
Ino. All rights reserved.
Specifications are subject to change without notice.
48
ENGLISH