Note – Sony SLV-M10HF User Manual

Page 43

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

If you cannot get your VCR to control the cable box/DSS receiver

• Check that the Cable Mouse is connected to the CABLE BOX CONTROL

jack on the VCR.

• Check the position of the Cable Mouse.
• Place the cable box/DSS receiver and VCR away from each other. Do not

place the cable box/DSS receiver on top of the VCR.

• Try the setup again making sure to use the correct control code. If tlie

cable box still does not respond, try the other codes that are listed.

If your cable box still does not operate with the Cable Mouse, contact your
cable company to see if they can provide you with a compatible cable box.

Note
• Make sure you turn off the VCR when you plug in or unplug the Cable Mouse. It

you unplug the Cable Mouse and plug it in again, turn on the VCR before you use
the cable box/DSS receiver control feature.

Getting Started