Sony SLV-M10HF - Manual (Page 108)

Symptom
A tape cannot be inserted.
Remedy
• Check that a tape isn't already in the tape
compartment.
The remote commander does
not function. Make sure you are pointing the remote commander at
the remote sensor on the VCR.
Replace all the batteries in the remote commander with
new ones if they are weak.
If you are not using S-Link'^', make sure that both
miniplugs are unconnected.
The command mode of the remote commander is
different from the one of the VCR.
The channels on the VCR
cannot be changed. Make sure the CABLE BOX CONTROL option is set to
OFF.
The tracking meter does not
appear on the screen.
The recording condition of the tape is very poor and
tracking cannot be adjusted.
You cannot control other TVs. Set your TV's code number. The code number resets to
01 when you replace the batteries of the remote
commander.
The VCR needs to be cleaned. Clean the cabinet, panel and controls with a dry, soft
cloth, or a soft cloth slightly moistened with a mild
detergent solution. Do not use any type of solvent,
such as alcohol or benzine.
Additional Information