Attaching the external antenna connector, Attaching a uhfa/hf band mixer, Ohm coaxial cable – Sony SLV-M10HF User Manual
Page 105
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
General setup information (continued)
Attaching the external
antenna connector
w h e n
using a 300-ohm twin lead cable
for VHF/UHF antenna, use the EAC-32
antenna connector (not supplied) to
connect the antenna to the VCR.
300-ohm twin
lead cable
EAC-32 Antenna
connector
(not supplied)
1
Loosen the screws on the antenna connector.
2
Wind the twin leads around the screws on the antenna connector.
3
Retighten the screws.
Attaching a UHFA/HF band
mixer
when using both 75-ohm coaxial cable
and 300-ohm twin lead cable for VHF/
UHF antenna, use the EAC-66 UHF/
VHF band separator/mixer (not
supplied) to connect the antenna to the
VCR.
300-ohm twin
lead cable
EAC-66
UHFA/HF
band
separator/
mixer (not
I supplied)
75-ohm coaxial
cable
1
Loosen the screws on the mixer.
2
Wind the twin leads around the screws on the mixer.
3
Retighten the screws.
4
Connect the 75-ohm coaxial cable to the mixer.
Additional Information